Join Our Ford Truck Forum Today

Document your Ford truck project here and inspire others! Login/Register to view the site with fewer ads.

Register Log in

Recent content by tanman722001

  1. Trans question

    Yea i have a 4x4 Zf5 . just finding a pto for ZF5 is fun

  2. Trans question

    Later will ZF5 but for right know what to leave 4 speed in the truck. Since truck is a wrecker got to have PTO

  3. NC Roll Call

    Question does anyone have any 73-77 truck parts. I bought a 75 wrecker and trying to get it fixed up. And yea i 73-79 are the same parts to the most part.

  4. Trans question

    So if i can find and use a 86 model bell housing can i moded the firer wall to mount the res for the hyd clutch. Then see if splines are the same to use about same year clutch. Bc i really dont want to change trans right know. As the truck is a wrecker

  5. Trans question

    Hi everyone. Question is what bell housing to use. I just got a 1975 f350 and i have a 7.3 idi with low miles.truck has a FE motor in it and a granny 4 speed. Other the a 6.9 idi bell housing is there any others that will work? Thanks for any help

  6. NC Roll Call

    Hi everyone.

  7. NC Roll Call

    Hi guys how is everyone. Its been awhile since ive been around

  8. F350 rearend

    Hi on a 75 what other rear end besides a Dana 70 will bolt up? This for a dually rear end.Thanks Tony

  9. 3.0L V6 question

    Hi,I just got a 98 Ranger with the 3.0 and it came with a 94 3.0 motor. But the 98 motor isn't any good. And it runs off coil packs and no distributor and has a crank sensor. The 94 motor has a distributor. Is there any way I can take the harm. balancer off the 98 and put on the 94 motor. And...

  10. Have a chance to buy

    Ok sorry. Yes is spins over. Just won't start. I will check the wire. Still working on a deal. He want my s10 and & $1300. Going to try to get it cheaper since its not running. And thanks again

  11. Have a chance to buy

    Ok update. Got the starter installed. Will not crank. Thinking injector pump is out. Getting fuel to fuel filter. But nothing to bleeder screw on pump. What you all think?

  12. Have a chance to buy

    Well guy the 86 is back at dealer. I can get it for $2000. The starter is toast. But before I finally the deal will get a starter so I can get it to run. Make sure it will run.

  13. ball joint press question.

    OK thanks Ryan. That's what I figured just wanted to make sure. The one at my O'Reillys is like the one I linked. Thanks Tony

  14. ball joint press question.

    Anyone???

  15. OBS turbo rebuild

    Not hijack anyone's post. But what advantage is the bullet wheel?
See more
Top