NO one to blame but me!!!:headbang:I found everything I may need to fix codes just easier to dig all up at once from basements of 2 houses a garage and several trucks I use as storage .Just looking up vac lines diagram for maf equipped truck when saw your reply
Well have several codes
Dug All related new sensors out of my parts boxes .96 plastic vac can and vac tube harnesses An extra new dizzy I bought years ago .eCU Couple Maf etc etc. all ready to start testing stuff .Long short I opened my hood to to make sure I didn't forget anything...
OK by hood hing there is a capped connector has a singe wire/plug and another with several remove cap take jumper from single to right right one on upper 2 . Just did it .
You need to go to a body shop . Not diesel shop . They do make above arch panels but the bottom edges go to. If you get into putting a whole bed side on .
For part expense and labor for sides I know you could get a good bed . I 'll have over $600 in bed side panels . And cross-member will...
A longer tube a bend towards front like years past cost little. Listen up ford .I hate check these at work . Its dark . the older ones you at least could see them
Due to most states requirements for fog/driving lights only to work on low beam they auto shut off on highs.. Its done that way . I can't get my trucks state inspection if change them . You would have to wire spearatly as they are tied into Parking and headlights.
Well guys after 8 trips for parts due to no parts house here having both left and right of things. Going to their other stores just to get parts same day . Getting 2 passengers side calibers (and having to wait another day to get it) Gave me 2 out of 6 brake lines with metric instead of SAE ...
Man if you were in PA . I'm going to pull trans out of my 95 to put in my 94 . Frames good all new hangers . It will probably be scrapped . No one wants whole trucks any more now that we have u pull
As title says its time its all have left to drive after end jan when my 95 "barney" will not pass inspection due to rust . Its that or sell as package to someone and get a car .94 F150 MAF 302 e4od 4x4Been starting it every month or so since parked in 13 . But the trans started to stay in...
I have a 95 e40d truck thats had everything check replaced multiple times and new valve body.
was Ford rebuilt that acted up 1 yr old after install and never was fixed completely . Will go for months a them act up again with no codes . After way to much $ Been driving it for 3 yrs now . I...
Thanks . I used to do body work so know about hidden rust. I usually do go to south to get my cars but . With limited funds and work now I'm stuck in my area (2hr drive anyway ) More than a day trip is more than can do. With plane gas I'd be down big on what I could spend .Waiting to see...
My 95 is done as of next spring because of rust . My 94 tho solid is in need of so much .that cost is not worth it for dialy driver. So what ya think?Do to limited funds . About newest I can go is 05 06 .I found a 06 F250 reg cab long bed 5.4 4x4 With 110000 miles taken care of but...
Thier part are inexpensive (and door panels fade fast ) and they charge to much $ for them and 3x shipping of other sellers . LOLThere are several places to get them . My upull gets 20 trucks month or more . And I have sent lots to guys on here .in past Look around they are out thereMy...
There part are inexpensive and they charge to much $ and 3x shipping of other sellers . LOLThere are several places to get them . My upull gets 20 trucks month or more . Look around My 225000 mile truck interior looks new except headliner /